how to enable band selection for MR600 VR2

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

how to enable band selection for MR600 VR2

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Khansu

2021-05-20 21:52:56 - last edited 2021-05-21 02:39:43

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-05-20

how to enable band selection for MR600 VR2

2021-05-20 21:52:56 - last edited 2021-05-21 02:39:43

Model: Archer A10

Hardware Version: V2

Firmware Version: 1.3.0 0.9.1 v0001.0 Build 210208 Rel.61056n

How to enable band selection?

1 Reply

Kevin_Z

2021-05-21 02:46:47

Posts: 21755

Helpful: 5136

Solutions: 2565

Stories: 21

Registered: 2018-12-24

Re:how to enable band selection for MR600 VR2

2021-05-21 02:46:47

@Khansu

MR600 v2 supports band selection on the current firmware, you can go to the router web GUI, then click Basic > Internet or Advanced > Network > Internet, you will find it.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

how to enable band selection for MR600 VR2

how to enable band selection for MR600 VR2

Information

Voters 0

Tags