Authentication failing for PPPoE on MR200

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Authentication failing for PPPoE on MR200

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Authentication failing for PPPoE on MR200
Authentication failing for PPPoE on MR200
2021-05-17 06:54:33 - last edited 2021-05-17 08:32:33
Model: Archer MR200  
Hardware Version: V5
Firmware Version: 1.2.0 0.9.1 v0001.0 Build 210120 Rel.67320n

I am trying to set up the 3G and 4G Backup on my MR200 router by following below link

https://www.tp-link.com/in/support/faq/2719/

 

But the PPPoE connection always fails with the following message in the log

ppp0 sent [LCP TermReq id=0x3 "Failed to authenticate ourselves to peer"]

 

I cross-checked ISP provided username/password and the mac address, all seems correct as the same settings works on another router(C6). Tried with a factory reset and followed the same link again but could not get sucess. 

 

Can someone help me in resolving this? 

  0      
  0      
#1
Options
1 Reply
Re:Authentication failing for PPPoE on MR200
2021-05-17 10:56:20

@Sujil_C 

 

Hey

 

The only time I have ever seen this error it was either the username / password or one of the settings.    Include a screenshot if you can of the old and new setup

 

This link might help!

 

https://www.tp-link.com/lk/support/faq/596/

 

 

  0  
  0  
#2
Options