Ethernet only one port working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Ethernet only one port working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Darof

2021-05-13 20:27:52 - last edited 2021-05-14 02:00:26

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-05-13

Ethernet only one port working

2021-05-13 20:27:52 - last edited 2021-05-14 02:00:26

Model: Archer C9

Hardware Version: V1

Firmware Version:

Hi,

i am struggling to fix this issue for over a month now. After restarting both my virgin hub 3 and Tplink Archer to factory settings due to connection issues i seem to not be able to use more than one ethernet port. i have put my hub 3 into modem mode, the tplink connects to my mac via ethernet cable and i have perfect connection on that however i am trying to connect another ethernet cable to my cat6 however i do not get any connection, i have been searching online to find a fix but i cant seem to find anything about this.

thanks

1 Reply

Kevin_Z

2021-05-14 07:50:59

Posts: 21785

Helpful: 5164

Solutions: 2575

Stories: 21

Registered: 2018-12-24

Re:Ethernet only one port working

2021-05-14 07:50:59

@Darof

Please show us a screenshot of the WAN IP address on the Status page.

When you connect another device to another LAN port of the C9, will the corresponding LED show up? Please check if the device can get a valid IP address from the router. You can try with different cat5e or cat6 cables.

BTW, when did you buy the router, was the LAN ports working fine before? Try to reset it to factory defaults, don't change any setting on the router, connect two computers to the LAN ports simultaneously, check if both can get the valid IP address from the router.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Ethernet only one port working

Ethernet only one port working

Information

Voters 0

Tags