Archer MR600 not beein dualband
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a problem with my Archer MR600 not beein dualband ... when i select 2 different bands ( 8 and 20 ) it only shows one of both but both function individually.
if I'm not mistaken, the band 8 is in 900 MHz, reserved for 3G and can't be aggregated with band 20 for 4G LTE. When you select band 8 alone, you still in 3G, not 4G!
Try to check all the frequency bands offered on your 4G provider's antenna.
For my MR-600 I have only the choice for 4G LTE, with my operator, of the following combinations:
Band 3 (1800 MHz) + band 20 (800 MHz)
Band 3 (1800 MHz) + band 28 (700 MHz)
I chose B3 + B28 combination because the B28 has better reception (75%) than the B20 (50%).
No band 7 (2600 MHz) for me on the mast, which would be a better choice than band 3.
4G+ LTE band's aggregations for Archer MR600:
if I'm not mistaken, the band 8 is in 900 MHz, reserved for 3G and can't be aggregated with band 20 for 4G LTE. When you select band 8 alone, you still in 3G, not 4G!
Try to check all the frequency bands offered on your 4G provider's antenna.
For my MR-600 I have only the choice for 4G LTE, with my operator, of the following combinations:
Band 3 (1800 MHz) + band 20 (800 MHz)
Band 3 (1800 MHz) + band 28 (700 MHz)
I chose B3 + B28 combination because the B28 has better reception (75%) than the B20 (50%).
No band 7 (2600 MHz) for me on the mast, which would be a better choice than band 3.
4G+ LTE band's aggregations for Archer MR600:
