Home

Forums

Stories

Knowledge Base

Home Network Community > Range Extenders > Tplink RE450 V3 doesn't work after flashing with OpenWRT

< Range Extenders

Tplink RE450 V3 doesn't work after flashing with OpenWRT

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Tplink RE450 V3 doesn't work after flashing with OpenWRT

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

WinterX

2020-12-24 17:07:03

Posts: 1

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2020-12-24

Tplink RE450 V3 doesn't work after flashing with OpenWRT

2020-12-24 17:07:03

Model: RE450

Hardware Version: V3

Firmware Version:

Hi guys,

I've probably done something wrong when flashing a custom firmware for my Tplink RE450.

Now it starts as normally then after 20-30 seconds only POWER LED is on. Nevertheless, I can't connect to it and it's not visible via WiFi. Any ideas how to revert back to the original firmware?

Thanks in advance.

2 Reply

TP-Link

2020-12-29 09:37:29

Posts: 6831

Helpful: 3101

Solutions: 537

Stories: 28

Registered: 2018-07-23

Re:Tplink RE450 V3 doesn't work after flashing with OpenWRT

2020-12-29 09:37:29

@WinterX

Hello,

Thank you very much for your time and patience.

Would a factory reset on the extender help or not?

If nothing happened, I am afraid the extender is broken.

Really sorry for the inconvenience.

Thanks a lot for your understanding and support.

Deco Monthly Recap- Check What's Currently Going on With Deco KidShield Test Recruitment, Share Your Ideas With us! Wi-Fi Schedule Ideas Wanted!

Hrubi

LV1

2021-04-26 18:03:50

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-04-26

Re:Tplink RE450 V3 doesn't work after flashing with OpenWRT

2021-04-26 18:03:50

@WinterX I had a similar issue on RE450 v3 and managed to restore the original firmware after using these steps.

Link to answer on OpenWrt forum

At that link you can find also an uploaded copy for the image I've used to restore the firmware. Be ware that this is valid for RE450 v3 only.

You can compile the stripping project and adjust your image as needed starting from the official firmware version.

Best of luck!

Tplink RE450 V3 doesn't work after flashing with OpenWRT

Tplink RE450 V3 doesn't work after flashing with OpenWRT

Information

Voters 1

Tags