LED Strip Controller needed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

LED Strip Controller needed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
LED Strip Controller needed
LED Strip Controller needed
2020-12-23 08:56:45
Model: Deco P9  
Hardware Version:
Firmware Version:

Hi there, I'm looking for led WiFi led controllers that will work with my P9 network. I've tried the cheapo Magic Home units that are widely available under a variety of names, but they connect for a while and then freeze (there is an existing thread about these with no resolution). 

 

So has anyone successfully used any other type of led controller (or got the Magic Home ones to work reliably).

  0      
  0      
#1
Options
3 Reply
Re:LED Strip Controller needed
2020-12-25 08:16:03

@Stricko 

Good day,

Thank you very much for your time and patience.

 Maybe you could have a look at our own LED strip:

https://www.kasasmart.com/us/products/smart-lighting/kasa-smart-led-light-strip-kl430

 

Thanks a lot!

  0  
  0  
#2
Options
Re:LED Strip Controller needed
2020-12-25 13:18:29

@Stricko It's a strange thing to be doing on Xmas day I know but I hate a unresolved technical issue. So I was wondering if any other mesh networks were having a similar problem with the Magic Home controllers.

 

And bingo. Found this on an eero forum

 

Take the controller PCB out of its case! It seems like the power and or receiver wires pass over the WiFi antenna on the PCB. Move the wires away and the WiFi connection stays stable

 

  0  
  0  
#3
Options
Re:LED Strip Controller needed
2020-12-25 13:18:31 - last edited 2020-12-25 15:39:34

@Stricko It's a strange thing to be doing on Xmas day I know but I hate a unresolved technical issue. So I was wondering if any other mesh networks were having a similar problem with the Magic Home controllers.

 

And bingo. Found this on an eero forum

 

Take the controller PCB out of its case! It seems like the power and or receiver wires pass over the WiFi antenna on the PCB. Move the wires away and the WiFi connection stays stable

 

https://www.reddit.com/r/eero/comments/jh6h6r/solved_magic_home_pro_devices_incompatibility/

 

https://i.imgur.com/pUXPA0S.jpg

 

 

  0  
  0  
#4
Options