Not connecting to wifi
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Not connecting to wifi
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Helo
I bought Tp link archer C6
Hardware version 2.0
Firmware version 1.3.6
I changed my router ip
After that i enable WDS from system parameters and connect to old router wifi
And i disable DHCP and restart the c6 router
After restart
I'm not able to connect to the wifi of c6 router
I tried from different device, mobile, laptop
Still not connecting
I reset 5 TIMES
Whenever i disable DHCP
I'm not able to connect to router
Please help
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Yes i kept same subnet of root router
But its same
Its taking soo much time to connect to c6 wifi after disable DHCP
If i enable DHCP I'm able to connect to c6 wifi quickly
And WDS not working
No internet getting
On terminal i type
ping <root router ip address>
It says unreachable
- Copy Link
- Report Inappropriate Content
When you set up WDS following the reference I sent, did you check in (C6) Advanced > Status > Wireless to see the WDS status ?
When the WDS status is Run, it means WDS bridging is successfully built.
- Copy Link
- Report Inappropriate Content
yes in status its showing WDS run
but internet not working
and if disable DHCP
its taking soo much time to connect to c6 wifi, like 10,20 minutes sometime more
it shows exclamation mark ! on my mac
check screenshot
- Copy Link
- Report Inappropriate Content
Exclamation mark means you don't have an Internet connectivity.
DHCP should be OFF for sure. What's the main router model ?
You are using 2.4 GHz band for WDS right ?
- Copy Link
- Report Inappropriate Content
yes i'm using 2.4ghz
i want to extend the range of this jiofi device
https://www.amazon.in/Reliance-JioFi-3-Personal-Hotspot-Router/dp/B07197M35D
i'm able to extend it with Mi router 4c and with tp link 300N model
but couldn't extend with Tp link c6
and during exclamation mark
i cannot access to router admin panel http://tplinkwifi.net/
after 10-20minuter fully connected then only i'm able to acces the router admin panel
- Copy Link
- Report Inappropriate Content
Read through this thread and see if you are affected by the same problem, I believe the user have successfully resolved that at the end.
- Copy Link
- Report Inappropriate Content
Not working
My problem will be solve if you can give this firmware version
On my c6 router admin panel
There are missing options as compared to this video
https://youtu.be/QCCkT19tj8A
On this video
In operation mode
switch to range extender
After that goto wifi 2.4ghz or 5ghz
And click scan to search other nearby wifi router for range extender
But on my c6 router there's no scan options
Can you give that firmware please
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
This video refers to some other model TP-Link device. Archer C6 v2 doesn't have Range extender mode - only Router and AP mode, thus you don't have Scan button in your wireless settings interface. All the FW that I have access are publicly available via TP-Link's web portal.
Have you read through the thread I mention in details ? There are couple of tweaks that may help you with the WDS issue. WDS is your only option.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2974
Replies: 18
Voters 0
No one has voted for it yet.