Set channell on Archer MR600

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Set channell on Archer MR600

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Set channell on Archer MR600
Set channell on Archer MR600
2020-10-17 22:35:26 - last edited 2020-10-19 05:26:21

Hi guys i've buy a couple day ago an Archer MR600...but i don't find the for change the channel radio. This option is present on this device?If yes, where is it?

Thank u

  0      
  0      
#1
Options
3 Reply
Re:Set channell on Archer MR600
2020-10-21 05:58:38

@BullSlevin88 

Good day,

Thank you very much for your time and patience.

Sorry for the delay.

May I know why you want to change the channel radio

For the channel radio, do you mean the wireless channel and channel width, such as channel 1-13 for 2.4ghz, or LTE band, like band 1/3/40?

If it is the wireless channel, you could find it under advanced>wireless> wireless settings;

For the LTE band, you might need to install the beta firmware since the current official firmware is not supported manual band selection.

Thanks a lot.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  3  
  3  
#2
Options
Re:Set channell on Archer MR600
2020-10-24 11:50:17

@Sunshine thank u for the reply...yes I use the router with the LTE sim..so i think isn't impossible change the WiFi channel with this fw. About the beta fw can u pass me it? 

  0  
  0  
#3
Options
Re:Set channell on Archer MR600
2020-10-29 06:45:10

@BullSlevin88 

Hi!

The firmware which supports manual band selection has been sent and please have a check of your message box.

Thanks a lot.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#4
Options