AC1900 router upgrade issue
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
I recently bought the wifi router and started experiencing frequent reboot issues with it. So to check if it can be rectified tried upgradation to
V1_200628
Since then the router is in a hung state. I tried to contact support but without any response..
Does anyone has faced similar issue and is there any solution to it?
Personally I am not able to do any sort of troubleshooting, the Wifi network doesnt show up post upgrade. All the ledsare always on and Power led is always flashing
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello, I have just replied you in this thread:
https://community.tp-link.com/en/home/forum/topic/219820
You need to connect this C80 to your computer with an Ethernet cable first.
- Copy Link
- Report Inappropriate Content
Hello, I have just replied you in this thread:
https://community.tp-link.com/en/home/forum/topic/219820
You need to connect this C80 to your computer with an Ethernet cable first.
- Copy Link
- Report Inappropriate Content
@Kevin_Z
hi Kevin,
thanks for ur reply. I see that my model is Archer C80(US) Ver:1.0.
I was going thru ur link to find the firmware to download and at the following link I can only find firmware for EU.
https://www.tp-link.com/in/support/download/archer-c80/#Firmware
There is also a warning at https://www.tp-link.com/in/support/faq/46/, where they says
"The firmware of EU and US are different hardware versions, do not use each other's firmware to upgrade your device."
Where can i find firmware for my exact model Archer C80(US) Ver:1.0. ?
thanks
Sri
- Copy Link
- Report Inappropriate Content
Hello,
If your hardware is a C80US, please try to get the latest firmware on the below website:
https://www.tp-link.com/us/support/download/archer-c80/#Firmware
May it help~
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 606
Replies: 3
Voters 0
No one has voted for it yet.