Names used for "Known Device Alerts"

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Names used for "Known Device Alerts"

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Names used for "Known Device Alerts"
Names used for "Known Device Alerts"
2020-08-13 15:25:04
Model: Deco M9 Plus  
Hardware Version:
Firmware Version:

I'm curious. Why do the "Known Device Alerts" use the default names of the devices connecting/disconnecting, rather than the NEW names I have changed them to in the device list? The default hardware names are VERY difficult to distinguish and often are "unknown" or just blank alerts when I receive them. That's why I looked up each MAC address in my network and renamed them on the router.

  0      
  0      
#1
Options
2 Reply
Re:Names used for "Known Device Alerts"
2021-02-07 02:27:57
I was wondering about this myself as it is very annoying and confusing
  0  
  0  
#2
Options
Re:Names used for "Known Device Alerts"
2021-02-09 02:29:45

@NeilKY 

Hi,

Have you tried to reserve the IP address for these devices to have a look;

Could you please test if all the mobile devices have the same issue?

Since I just tested on my phone and if the device name has been changed,  it still showed the name that I have changed when it was disconnected from the Deco and connected back,

Thank you very much and wait for your reply.

 

 

  0  
  0  
#3
Options