Router dead during fault upgrade
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
The router not responding after fault upgrade, during upgrade it stay static at about 30%, after restart, it is not connecting to both tplinkwifi.net, nor 192.168.0.1.
i tried to follow the steps in the manual but unfortunately the step of accessing 192.168.0.1 was not succeful. the only blue line in the router is the two arrows visversa.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
Do you still use the original power adapter?
Try one more time to hard reset it by holding the reset button or hole for 10s.
It is suggested to refer to the guide below to do a firmware recovery:
https://community.tp-link.com/en/home/stories/detail/582
When and where did you buy this also? If nothing can make it power on correctly, you may need to contact the local tech support to check the warranty cause the device seems faulty:
https://www.tp-link.com/en/support/contact-technical-support/#Hotline-Support
Good day.
- Copy Link
- Report Inappropriate Content
Hi,
Do you still use the original power adapter?
Try one more time to hard reset it by holding the reset button or hole for 10s.
It is suggested to refer to the guide below to do a firmware recovery:
https://community.tp-link.com/en/home/stories/detail/582
When and where did you buy this also? If nothing can make it power on correctly, you may need to contact the local tech support to check the warranty cause the device seems faulty:
https://www.tp-link.com/en/support/contact-technical-support/#Hotline-Support
Good day.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1203
Replies: 1
Voters 0
No one has voted for it yet.