Can't get NTP time

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Can't get NTP time

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Can't get NTP time
Can't get NTP time
2020-07-24 20:33:27 - last edited 2020-07-27 06:37:25
Model: TL-WR941HP  
Hardware Version: V2
Firmware Version: 2.0.1 Build 20180305 Rel. 54795

I'm using it in AP mode and it works. The only problem is that it is not possible to get the NTP time. I guess it is because there is no way to set the gateway or a route rule. Also there is no option for DHCP.

The modem IP is 192.168.1.1. The cable is connected to a lan port not to the wan port. Is there a way to fix it?

  0      
  0      
#1
Options
1 Accepted Solution
Re:Can't get NTP time-Solution
2020-07-27 06:37:14 - last edited 2020-07-27 06:37:25

@Kakao 

 

Hello,

 

You are correct, the NTW server will not synchronize successfully if the 941HP works in AP mode and uses a static IP address, you may need to change it to dynamically getting the IP address from the host router.

 

Good days.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Can't get NTP time-Solution
2020-07-27 06:37:14 - last edited 2020-07-27 06:37:25

@Kakao 

 

Hello,

 

You are correct, the NTW server will not synchronize successfully if the 941HP works in AP mode and uses a static IP address, you may need to change it to dynamically getting the IP address from the host router.

 

Good days.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options