Archer C6 - Ethernet capped at 100mbps even when negotiating 1000mbps full duplex
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Archer C6 - Ethernet capped at 100mbps even when negotiating 1000mbps full duplex
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a hard drive connected to the USB port of the main modem/router (provided by my internet provider), shared on the network via SMB. The archer C6 is connected to the main router via a cat5e cable, and negotiates a 1000Mbps full duplex connection. If i try to copy a file from the hard disk to my laptop while connected with an ethernet cable to the main router or while connected via WiFi to the Archer C6 I get speed of ~250Mbps in both cases, which is as expected. But if I'm connected via ethernet to the Archer C6, while still negotiating 1000Mbps full duplex from the main router to the Archer and from the Archer to my laptop (checked both in Windows' control panel and in the Archer C6 configuration page), the speed I get is capped at 100Mbps, and is usually lower, at around 70Mbps. Did I get a defective unit or is this a flaw of the product itself, which is marketed as having full gigabit ports?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Kevin_Z I have one additional question.
I bought Archer C6 and I am using it as access point.
My internet speed is currently 240Mbps. The main router gets 240Mbps on both WiFi and cable. I also reach this speed on the CAT6 cable that I use to connect to the Archer C6.
I followed your instructions and go to Advanced-system tools-system parameters to edit the duplex in the Router mode, and changed it to 1000Mbps full-duplex. After saving, I changed the operation mode to Access Point mode but the internet still gets capped on ~100Mbps.
My question is: Archer C6 can work as an access point and provide more than 100Mbps?
I appreciate your time and attention.
Regards,
Fabio
- Copy Link
- Report Inappropriate Content
Do you mean the speed gets capped at ~100Mbps when you connected to the C6 wireless network? 2.4GHz or 5GHz? How about the link speed, confirm it as this link?
Generally, the negotiation speed will only affect the wired connection, while if the WAN negotiation is limited to 100Mbps, you won't be able to get more than 100Mbps on the clients, no matter they are connected via CAT6 cable or via Wi-Fi. As you mentioned that you can get ~240Mbps when you connect the laptop to it via CAT6 cable, so I think this is not an issue in your case.
You may refer to the below guide to reconfigure the C6 to work as an access point manually (Case 2):
https://www.tp-link.com/support/faq/1384/
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 7373
Replies: 12
Voters 0
No one has voted for it yet.