Archer MR600(EU) V1 - BETA Firmware - Allowing selection of 4G+bands for Archer MR600 manually
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi all,
Following the long thread on the same subject discssing the BETA FW, as I said I would, TPLink have given me permission to share the FW download llink.
From TPLink - We recently released a beta firmware for Archer MR600(EU) V1 which can allow us to select 4G+bands for Archer MR600 manually.
https://static.tp-link.com/2020/202004/20200420/Archer_MR600v1_1.1.0_0.9.1_[200417-rel75138]_up_boot_2020-04-20_08.44.31.zip
For Archer MR600, if you want to use its 4G+network, your SIM card should support the CA bands group Archer MR400 supports. Please check the attached picture and check if your SIM card supports the band groups on the list or not.
They asked me to state that, this BETA FW is for the Archer MR600(EU) V1 ONLY!
Neither TPLink nor me take any respnsbility if you flash a none-EU router.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Intraband 40 CA is not yet supported by TP link MR600
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@darant Yes, itis better to use an external antenna with minimum cabling so you can get the same signal and speed without any transmission loss. If you have very strong single then Patch panel antenna would do the job. In case of issues of signal dropping then I would suggest you to go with 2 LPDA 12 dBi antenna with LMR200 cable of 5 meter so you can gain the maximum signal and speed. Both the antenna and cable can be purchased through any vendor, however i found synergyRF solution is lway cheeper on LPDA antenna prices ( 12 dbi LPFDA antenna is around 650 rupees . So 2 12 dbi + 2 5 Meter LMR200 cable with connectors would cost you less than 2000 rupess and you can get the mximum speed and other important parameters required for Voice traffic
- Copy Link
- Report Inappropriate Content
@Abhi093 Hi Abhi, Pls share a photo and vendor details of your MIMO antenna in the personal message.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Can you please share with me too?
- Copy Link
- Report Inappropriate Content
@Abhi093 Can you share the pictures on how did you mount the LPDA antenna and the spacing that you use between each?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 13
Views: 193304
Replies: 511
Voters 10
