WiFi roaming in deco x20 access point mode
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have Ethernet cable connect different rooms in my home. I am going to create a seamless roaming WiFi network. Can I just buy deco x20 and setup it up as access point mode for WiFi roaming? My existing router can still serve as a router.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
The seamless roaming happens only among Deco products because they support the complete 802.11k/v/r roaming protocols.
Your existing router can still serve as a router, however, it's recommended to disable its Wi-Fi network so that your client will roam seamlessly between Decos only.
- Copy Link
- Report Inappropriate Content
But, the question is, if you connect each Deco with ethernet, set each as access point, here the point of using the ethernet is to assure fast and reliable connectivity to the router.
With this setup, will you still have fast roaming? will the Decos still follow the 802.11k/v/r roaming protocols ?
- Copy Link
- Report Inappropriate Content
Hi,
Are the Ethernet cables go to different rooms all from the same router? If so, when Deco works in the AP mode and connected to the Ethernet cable, they can also build one mesh network and follow the 802.11k/v/r roaming protocols.
- Copy Link
- Report Inappropriate Content
Yes, all Deco's would go to different rooms using ethernet cat 6 cables, all comming from the same router.
So, is this behavior by default (fast roaming following 802.11k/v/r roaming protocols) even in AP mode?
- Copy Link
- Report Inappropriate Content
Yes, Deco will follow 802.11k/v/r roaming protocols even in the AP mode.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Yes, Deco X60 follow 802.11k/v/r roaming protocols even in the AP mode
- Copy Link
- Report Inappropriate Content
My x20 deco's are in Access point mode, but when I connect my non-main deco's to the same switch a get een loop error... It looks like the don't act as Access point.
- Copy Link
- Report Inappropriate Content
Hi, thank you very much for your kind feedback.
Could you please send me a picture of your network diagram from ISP router to Deco X20?
And what are the model number of the main router and the network switch?
As for the loop error, where did you see this error, on the switch?
Thanks and wait for your reply.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3738
Replies: 9
Voters 0
No one has voted for it yet.