C5400X and what type of LACP for WAN Aggregation does it support???
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
Trying to figure out why I don't have a dropdown in the GUI for the WAN aggregation toggle that shows whether or not it's Passive or Active LACP to config. Any guidance would be very helpful:) I see this in the support documentation, but its not available in the router GUI. Maybe a Bug???
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello, the Archer C5400X supports LAN link aggregation. And it supports layer 2 LACPonly.
You can refer to the instruction below to get more information and set it up.
https://www.tp-link.com/support/faq/1583/
- Copy Link
- Report Inappropriate Content
But in those instructions, I don't have an option for Active/Passive or port selection. So It may be a bug in the firmware as there is no drop down box.
- Copy Link
- Report Inappropriate Content
Thanks for your reply.
It is not a bug, the settings page varies due to different model numbers. The Archer C5400X supports WAN Link aggregation passive mode.
- Copy Link
- Report Inappropriate Content
I have a archer c4000 and same issue for LAN link aggregation, it's settings not the same as your reference link, just static lag and not have dynamic option 802.3ad layer2, layer3 or any info. about which teaming modes device supports???
I also ask the community and created ticked this issue as a different topic but no one relply. I think tp-link's customer support is poor...
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 1484
Replies: 4
Voters 1
