2.4 ghz not detected
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Suddenly the 2.4 ghz is not detected by all devices.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Does the 2.4GHz wifi light on on the router? If the light is normal, you can log in to the router's management page, change the 2.4GHz Network Name to a different one, change the Channel to 1 or 6 or 11.
If it still not working, you can factory reset the router by press the reset button for 10 seconds, then check whether you can see the default 2.4GHz wifi signal or not.
Have a nice day.
- Copy Link
- Report Inappropriate Content
What about the 2.4GHz wifi led? You can hold the wifi button to turn it on.
And you can log into the web UI of the Archer VR2800 and go to the advanced-wireless-wireless settings page to verify whether the 2.4GHz has been enabled.
You can change the wireless channel also.
If it still cannot be detected, you can hard reset it to give it a go.
Good day.
- Copy Link
- Report Inappropriate Content
@Kevin_Z Good evening
I tried all these steps and hard reset. Unfortunately still cannot detect 2.4 ghz. I get error 9805: corresponding case not found.
- Copy Link
- Report Inappropriate Content
Hello,
You may need to contact the tech support to check the warranty cause the device seems faulty.
https://www.tp-link.com/en/support/contact-technical-support/#Hotline-Support
Good day.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 945
Replies: 4
Voters 0
No one has voted for it yet.