OneMesh for Ax6000
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer ax6000 is scheduled for onemesh as per the compatibility page.
Could you please advice on when the firmware will be available?
is it possible to beta test a new firmware? I have the RE300 and AX6000
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Ok Kevin. The extender took ages to give the note 10 an ip address. Too long to be of any use. Also 2 other devices were without internet at the same time which were very near the extender.
Alll were showing as unknown devices with a 0.0.0.0 ip address.
The xtender is now an extender only with mesh and smart connect on router turned off. It has the same wi fi names as the ax6000 and it works ok.
I will try on the weekend your suggestion of reinstate mesh but leave smart off.
- Copy Link
- Report Inappropriate Content
Thank you very much for getting back with the detailed info. Kindly give it a go to disable the Smart Connect while leave the Onemesh on, then monitor again.
To locate this issue and try to fix it, we would like to follow up on your case via email. Please respond to the email directly if the issue persists.
- Copy Link
- Report Inappropriate Content
Hi, we hope you could spend some time on the Onemesh survey, then we will better understand your requirements, thank you:
- Copy Link
- Report Inappropriate Content
@localhost192 I finally updated the software to enable OneMesh for my AX6000 and RE505X. I have the RE505X set up as a wired access point. There is no OneMesh in the menu for it when I checked after the firmware update of the AX6000. What's the deal? I switched the RE505x to extender mode and then it showed up. Seems shortsighted to not be able to us the RE505X as a wired extender and use OneMesh at the same time. I need a range extender because it's far away from the main router!
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
The OneMesh™ products can’t support the Ethernet backhaul. We currently only have Deco supports the Ethernet backhaul.
For more details, please refer to the below FAQ:
- Copy Link
- Report Inappropriate Content
Hi @Kevin_Z
I have three AX 6000 and two RE605, it possible to connect all of AX 6000 and extenders in one WiFi network with "onemesh" support, or AX 6000 works only with extenders, without possibility to works with each other??
Tnx for your answer,
- Copy Link
- Report Inappropriate Content
Are all the three AX6000s and two RE605s in the same location? Unfortunately, the Onemesh router can only build up the Onemesh network with the Onemesh RE or Onemesh PLC. In your situation, we think Deco mesh would be more suitable for your needs:
But please also keep in mind that the Onemesh devices are not compatible with Deco mesh, they cannot build up the same mesh network:
- Copy Link
- Report Inappropriate Content
Information
Helpful: 4
Views: 28242
Replies: 78
Voters 4
