MR6400(eu) can't work with 700MHz(28 band)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

MR6400(eu) can't work with 700MHz(28 band)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

XxOinvizioNxX

2019-12-18 22:56:46

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2019-12-18

MR6400(eu) can't work with 700MHz(28 band)

2019-12-18 22:56:46

Model: TL-MR6400

Hardware Version: V4

Firmware Version: 1.7.0 0.9.1 v0001.0 Build 181214 Rel.49556n

I bought my TL-MR6400(eu) router in Russia and there it works great. But now I am living in Panama.

Here in Panama all providers are using 28 band (700MHz) and according to specefications (just like in reality) MR6400(eu) does not work. (Just writes that there is no signal, but SIM card is recognized)

On TP-Link website i found the APAC firmware version that according to specefications should works, but it is written not for the EU version.

And the question: Can I install the APAC firmware on my MR6400(eu) to make it works on 28 band? Or are there other ways to get it to work on this frequency?

Thanks.

P.S. Sorry for my bad English...

1 Reply

Kevin_Z

2019-12-24 10:58:05

Posts: 21776

Helpful: 5146

Solutions: 2575

Stories: 21

Registered: 2018-12-24

Re:MR6400(eu) can't work with 700MHz(28 band)

2019-12-24 10:58:05

@XxOinvizioNxX

Hello, sorry to tell you that we cannot install the APAC firmware over the TM-MR6400 EU version. The firmware need match its hardware version and country version both.

The APAC firmware adds the supportability of band 28 based on EU version. As far as I know, service providers support multiple bands, not only one. You can contact the provider to verify it.

Good day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

MR6400(eu) can't work with 700MHz(28 band)

MR6400(eu) can't work with 700MHz(28 band)

Information

Voters 0

Tags