Do you use a single antenna or a pair ??

@b15 hi it's this one.

 

Eightwood 4G Antenna 35dbi SMA Male Adapter Omni Directional Antenna 2m 6.5ft Cable + 2pcs SMA Jack Female to TS9 Plug Male Adapter for 4G LTE Router 2G 3G 4G GSM WLAN Bluetooth HSDPA UMTS DCS https://www.amazon.co.uk/dp/B07Y1N9ZTF/ref=cm_sw_r_cp_api_i_F3uXEbSWQRHDZ

I have just purchased the antenna mentioned above. 

I am in near perfect location, direct line of site to mast, about 1 to 1.5km away. 

 

Had the modem in the window, and literally replaced it with new antenna and put the modem in a tucked away corner.

 

I took a grab of before and after for people to see.

But IMO it works great, cheapish, does the job I wanted it for of not needing the modem in the window. Signal boost - I'd be hard pushed to say it's any different though. 

 

can we use sma male splitter to connect to the router ? 

How do we handle antennas which provide single sma male connections ?

@Kevin_Z   Hi i have tried with external antenna for MR600.. Initially i had doubt that this router supports or not but it  supports 12dBi/24dBi external antenna.

You can check my setup using Archer MR600  in the following link.Hope it helps ..Cheers :)

 https://www.youtube.com/watch?v=xVezOfxbpv8&t=13s

@SE-Fredd   HI . Initially i also had some doubt on external antenna.. But  i took a chance   and that finally worked.. You can check the Mr600 with external antenna setup in my video..Hope it helps 

https://www.youtube.com/watch?v=xVezOfxbpv8&t=13s

@sunchaser   Hi .. Yes this  supports external antenna. Hope the following link helps to solve your problem..

 And hope TPlink will be thankful to me for taking a chance like buying MR600 for a remote area as i shown in video :)

https://www.youtube.com/watch?v=xVezOfxbpv8&t=13s

@Kevin_Z  I have taken a chance to test MR600 with long cables and externa High gain antennas in a remote area,

You can check the complete setup and results in the following link.

Hope you can show this to your TPlink Tech team for refference..hope they appriciate it.

https://www.youtube.com/watch?v=xVezOfxbpv8&t=13s

@RajaneeshBhat 

 

Hello,

             I have few questions regarding your setup

 

Question 1:- While connecting to the router you have not directly connected the cable to the SMA Female input. what is the conenctor you have used between cable to the router

Question 2:- what is the purpose of the 24dBi MIMO parabolic grid antenna. Have you connected this antenna with LPDA antennas

Question 3 :- Here is my plan to address my issue please let me know does this a correct approach

- 2 12dBi LPDA antenna with N female connector

- 2 20 meter 0.5 inch RF feeder cable N SMA Female to SMA Female

Question 4:- Where can get the beta software to update my Modem to change the band . Quick reply from you to help me to place the order

Please share your contact details to my email id cbzvenki@hotmail.com

Cheers, I'll give it a try. Have tried a few others but no improvement so far, fingers crossed.