@Kevin_Z Hi, I am leaving the TP-Link router only for this issue! :( 

It's really an issue for me when I am not able to see my "Router Up Time" and my "WAN Connection Up Time"

So, I hope I will back to TP-Link again when your updated Firmware will have these 2 essential options.

Thank you! :) 

Displaying uptime is a must for any router. How can a manufacturer of routers not understand this?

  @STN Not sure why they removed it from their updated Firmware. 

But, I hope TP-Link will understand it soon. 

Even sometimes when I face a power fault, I can't able to understand whether my Router was restarted or not! 

The same thing for the WAN connection, I can't able to determine whether My ISP was disconnected today or not. 

Because the router is showing the WAN uptime as well. 

So, TP-Link should consider bringing back these 2 essential features into their Firmware.  

  @Tadeo 
My Router Model: C6 Mu-MIMO wifi router,

Device Information
Firmware Version: 1.0.14 Build 20211118 rel.43110(5553)
Hardware Version: Archer C6 v3.20

How can see system Uptime??

 

bizarre that there's no uptime stats for these routers, mine being an archer a6. it shouldn't be too difficult to implement.

one good use for uptime is when an external monitor service reports a short outage, the uptime figure would help rule out or rule in the router as the cause.

Same problem Archer C6 V4 no uptime show.

  @r0llyn They don't care about their customer's requirements! :D