TL-MR6400 DDNS and Remote Admin not working - wrong WAN IP addresses?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-MR6400 DDNS and Remote Admin not working - wrong WAN IP addresses?
Model :
Hardware Version :
Firmware Version :
ISP :
I have a TL-MR6400 with an EE pay as you go sim card.
I am ultimately trying to gain remote access to a web server attached to the router using port forwarding.
I am however unable to access the router remotely either via direct IP or via DDNS.
On a PC connected to the router I am able to access the internet and the status page of the router has Connection Status: Connected.
The router status page shows an IP address "100.124.XXX.XXX" (Ive used Xs to mask actual address and ill call this one .)
Using DDNS with noip reports a different ip address "213.205.XXX.XXX" . this is the same using the router DDNS to report IP or using the noip client on a PC.
Under remote management I have setup:
- Web Management Port: 8081
- Remote Management IP Address: 255.255.255.255
- Saved
I am unable to access remote management via :8081 or :8081. I have also tried a number of other port numbers
Pinging address is unsuccessfull
Pinging address is unsuccessfull
Running a tracert from a pc connected to the router does not show up either or .
I have no idea whats happening......
Any help greatly appreciated
Firmware Version:
1.0.15 Build 170912 Rel.75663n
Hardware Version:
MR6400 v2 00000000
Hardware Version :
Firmware Version :
ISP :
I have a TL-MR6400 with an EE pay as you go sim card.
I am ultimately trying to gain remote access to a web server attached to the router using port forwarding.
I am however unable to access the router remotely either via direct IP or via DDNS.
On a PC connected to the router I am able to access the internet and the status page of the router has Connection Status: Connected.
The router status page shows an IP address "100.124.XXX.XXX" (Ive used Xs to mask actual address and ill call this one .)
Using DDNS with noip reports a different ip address "213.205.XXX.XXX" . this is the same using the router DDNS to report IP or using the noip client on a PC.
Under remote management I have setup:
- Web Management Port: 8081
- Remote Management IP Address: 255.255.255.255
- Saved
I am unable to access remote management via :8081 or :8081. I have also tried a number of other port numbers
Pinging address is unsuccessfull
Pinging address is unsuccessfull
Running a tracert from a pc connected to the router does not show up either or .
I have no idea whats happening......
Any help greatly appreciated
Firmware Version:
1.0.15 Build 170912 Rel.75663n
Hardware Version:
MR6400 v2 00000000