Archer BE230 Won't switch to satellite mode
I want to set up a mesh and I have a BE230 router that I want to use as a satellite. I have reset it, connected to it and tried to change the onemesh setting to satellite. However, after the reboot, it still stays in main router mode.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@2001ASO After changing be230 to satellite dont touch it.
dont enter it interface.
go to main and just add be230 to mesh.
- Copy Link
- Report Inappropriate Content
Hi,
It is not supported to add an EasyMesh satellite router to an OneMesh main router via the graphical user interface. You will have to use the "WPS" method instead. (first start WPS on the AX6600 and then within two minutes press the WPS button of the BE230)
- Copy Link
- Report Inappropriate Content
@2001ASO After changing be230 to satellite dont touch it.
dont enter it interface.
go to main and just add be230 to mesh.
- Copy Link
- Report Inappropriate Content
@YuriyB I have left the BE230 and if I go to the AX6600 OneMesh setup it is not displaying any aditional devices.
- Copy Link
- Report Inappropriate Content
Hi,
It is not supported to add an EasyMesh satellite router to an OneMesh main router via the graphical user interface. You will have to use the "WPS" method instead. (first start WPS on the AX6600 and then within two minutes press the WPS button of the BE230)
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 273
Replies: 4
Voters 0
No one has voted for it yet.