Home

Forums

Stories

Knowledge Base

Home Network Community > DSL Modem Routers > wireless no reconnection

< DSL Modem Routers

wireless no reconnection

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

wireless no reconnection

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Hseyin

2024-06-13 18:37:54 - last edited 2024-06-28 12:08:43

Posts: 3

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-06-12

wireless no reconnection

2024-06-13 18:37:54 - last edited 2024-06-28 12:08:43

Tags: #Network Connectivity

Model: Archer VR400

Hardware Version: V3

Firmware Version: 1.5.0 0.9.1 v00a1.0 Build 220321 Rel.60385n

"Smart Connect" if it is not active, power off-on or in case of power failure, the devices could not automatically establish a wireless connection again. It is necessary to make the connection manually on the devices.

this has happened on more than 3 devices

i'm using translation, I hope I was able to explain my problem :)

1 Accepted Solution

Marvin_S

2024-06-14 03:42:07 - last edited 2024-06-28 12:08:43

Posts: 2279

Helpful: 165

Solutions: 385

Stories: 0

Registered: 2022-05-09

Re:wireless no reconnection-Solution

2024-06-14 03:42:07 - last edited 2024-06-28 12:08:43

@Hseyin

Hi, thanks for posting question here.

The issue sound a little strange. If the "Smart Connect" is off, did you set different wifi names for 2.4Ghz and 5Ghz wifi band? Can you share the screenshots of your wireless settings?

May I confirm the devices you mentioned usually connect to 2.4Ghz or 5Ghz wifi band?

You may take a factory reset and reconfigure the modem royter to check again.

Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode.

Recommended Solution

1 Reply

Marvin_S

2024-06-14 03:42:07 - last edited 2024-06-28 12:08:43

Posts: 2279

Helpful: 165

Solutions: 385

Stories: 0

Registered: 2022-05-09

Re:wireless no reconnection-Solution

2024-06-14 03:42:07 - last edited 2024-06-28 12:08:43

@Hseyin

Hi, thanks for posting question here.

The issue sound a little strange. If the "Smart Connect" is off, did you set different wifi names for 2.4Ghz and 5Ghz wifi band? Can you share the screenshots of your wireless settings?

May I confirm the devices you mentioned usually connect to 2.4Ghz or 5Ghz wifi band?

You may take a factory reset and reconfigure the modem royter to check again.

wireless no reconnection

wireless no reconnection

Information

Voters 0

Tags