Is this configuration viable?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Is this configuration viable?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Is this configuration viable?
Is this configuration viable?
2019-12-06 11:57:21

Thank you for your feedback.

 

Regards

 

  0      
  0      
#1
Options
2 Reply
Re:Is this configuration viable?
2019-12-06 13:04:05
Between the two P7, there is about 150feet, no wifi link possible. But the electric line is fine, I have previously used a couple of power-line adapters. I am tring to understand if the two P7 can be used in the middle of the mesh network. As TP-link recommend putting P7 as MAIN DECO. Here I have an M5. Thank you for your help.
  0  
  0  
#2
Options
Re:Is this configuration viable?
2019-12-09 06:11:23

@Jojo42 

 

Theoretically, you can use the Deco P7 as the slave Deco, and Deco M5 as the main router. While the distance between the Deco P7 units is far away, the wifi signal strength may be weak, therefore, the whole performance of the mesh network would be affected a lot. 

 

May it help. 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#3
Options