Can I add static routing over tun0 VPN interface?
I have an Archer C6(US) router, hardware 2.0 and firmware 1.1.4 build 20190923, configured as a OPENVPN server.
The routes created by the system for the VPN don't attend my needs. I need to add a static routing using the tun0 interface, but only the LAN and WAN interfaces appear. On the system routing table appears the tun0 interface, but it isn't available for the static routing.
How can I add a static routing using the tun0 VPN interface?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
After a long time without finding a solution using TP-Link firmware, I replaced it with OpenWRT (https://openwrt.org/toh/tp-link/archer_c6_v2) and was able to create the routes I needed.
PS. If you are going to replace the firmware, make sure you know what you are doing, as it can render your router unusable. There is a risk in the swap.
- Copy Link
- Report Inappropriate Content
I have the same question as above. Dear tp link support is it possible?
- Copy Link
- Report Inappropriate Content
@Passele ... Same here.... I can only select WAN and LAN intefaces.... It must be a bug.
- Copy Link
- Report Inappropriate Content
Same issue here... can TP-link please explain how this is possible... any command line way to do it?
thanks!
- Copy Link
- Report Inappropriate Content
@Passele some issue: https://community.tp-link.com/en/home/forum/topic/561210 anybody solve it since 2019 year?
- Copy Link
- Report Inappropriate Content
After a long time without finding a solution using TP-Link firmware, I replaced it with OpenWRT (https://openwrt.org/toh/tp-link/archer_c6_v2) and was able to create the routes I needed.
PS. If you are going to replace the firmware, make sure you know what you are doing, as it can render your router unusable. There is a risk in the swap.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 2543
Replies: 5
Voters 1
