How to configure VR2100 or VR400 so that WAN/LAN4 acts as a Backup internet connection.

How to configure VR2100 or VR400 so that WAN/LAN4 acts as a Backup internet connection.

How to configure VR2100 or VR400 so that WAN/LAN4 acts as a Backup internet connection.
How to configure VR2100 or VR400 so that WAN/LAN4 acts as a Backup internet connection.
Yesterday
Model: Archer VR2100  
Hardware Version:
Firmware Version:

Hello, 

 

Recently we have purchased a couple of VR400s and VR2100s and on the website it says that they both support Backup internet connection on WAN/LAN port. As you can see on the attached image. My question is how do I enable this feature ? 

  0      
  0      
#1
Options
2 Reply
Re:How to configure VR2100 or VR400 so that WAN/LAN4 acts as a Backup internet connection.
Yesterday

  @MartinGrossmann 

 

You've misunderstood the backup feature, but I have to admit that on the screenshot you posted it's a ittle bit misleading.

Actually the only backup connection for these DSL momdem routers is the 3G/4G network through a USB modem.

Using a WAN/LAN4 port is just an additional Wireless Router Mode (an alternative of the DSL Modem Router Mode).

For more details regarding this feature go through the user guide - Chapter 9.3.1.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#2
Options
Re:How to configure VR2100 or VR400 so that WAN/LAN4 acts as a Backup internet connection.
59 minutes ago

​To set up the WAN/LAN4 port on your Archer VR2100 or VR400 as a backup internet connection, first ensure your router is in Wireless Router Mode. This allows the LAN4 port to function as a WAN port. Connect your backup internet source to this port Slow Aging. For detailed guidance, refer to TP-Link's official instructions.

  0  
  0  
#3
Options