My previous Mesh hw was giving issues, purchased installed Deco 3x pods

All OK and updated various hw to the new, all OK

However the Epson WF-3820 would not connect, followed Epson web install full set up it found the ssd and connected but win11 itself couldn't find the printer.

The Deco pod identifies the Epson as ok, but win cannot find any printer

Uninstalled all Epson software, ran sfc/DISM all ok

Started the install again, the Epson printer Panel finds/sets up the deco ssd without problem but win cannot find any printer, Deco pod shows the Epson.

Redid the Epson setup and used another WiFi router ssd, this completed without any issues.

I'm perplexed, cannot find any Deco setting that might disable the printer connection