@klipse 

Hi, nice to see you again.

The WiFi signal broadcasted by Deco X60 should still support 802.11ax. May I know how you discovered that Deco X60 only has WiFi 5, not WiFi 6?

Have you saved any pictures of that?

Thank you very much and wait for your reply.

  @David-TP

Hello David

Thanks for your reply, I have resolved this now, I had recently swapped my main Deco from the X60 back to the M9 plus, once I rebooted the X60 the wifi 6 came back on.

My work laptop is wifi 6 capable so by looking at the wifi connection properties I could see the "protocol" was wifi 5.

All seems good now and very happy with my X60 Deco.

Thank you

Kevin

@David-TP 

Following this post my Deco X60 has been working well, however there are times when the X60 loses connectivity to the network and reconnects, this is fine as i know the reason for the loss of connectivity. (Ethernet backhaul drops to wifi backhaul etc)

The issue I have is that there does seem to be a bug in the X60 firmware, so when it loses network connectivity to the main Deco for whatever reason, X60 loses 802.11ax protocol, and reverts to 802.11ac protocol. I did mention this in my previous post but didn't think much of it at the time however after this happening a few times now I realise its probably not meant to be like this.

In order to restore 802.11ax protocol I need to reboot the X60 only and this is then resolved. Some pictures below from my wifi 6 capable work laptop.

First picture - after network connectivity is lost X60 wifi protocol changes to wifi 5.

Second picture - after a reboot of the X60 wifi protocol changes back to wifi 6.