DECO P9 Flow loss between my different DECO
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.DECO P9 Flow loss between my different DECO
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello
I will explain my installation: My orange livebox is connected by fiber, but it is outside my apartment in the corridor protected in a plastic box, I am in the apartment, and as a separation there is a big door and the wall which is a little thick. On this livebox, I have my first Deco P9 which is connected by ethernet, this first Deco P9 is inside my apartment, the ethernet cable goes under the side of the door, I checked the cable is not crushed or nothing. So normally with this configuration it should remove the obstacle of the plastic box and the door.
On this first Deco P9 I have a very good connection.
On the other hand after if I go to one of the rooms where there is another Deco P9 I really have a very big loss, and yet I have 3 bars out of 3 And the distances between the 2 deco are only a few meters and the walls are thick
What can the problem come from?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Probably the Deco P9 devices are connected to different electrical phases or through some power strips!
Do not connect Deco P9 devices in this way
- Copy Link
- Report Inappropriate Content
Ok I made some changes, my main deco P9 was plugged into the outside electrical outlet which must be on another electric current.
So I unplugged the main deco and I plugged it back inside, well it's not practical because the cable is in the middle of the passage so I will not be able to leave it like that, If anyone have a solution for this problem?
Then I reset the whole network, and on my other 2 deco P9 there is now brand CPL + wifi, but on the 3rd deco there is only wifi.
I did tests by changing the place, I switched the deco who had wifi + cpl with the one where I have only wifi, it does not change anything. The one who only picked up wifi continues to capture wifi and the one who captures wifi + cpl continues to capture the 2 I do not know what it can come from?
As I have 4 deco I think it may be the deco that I bought in addition to it, I do not know if there is a synchronization to do?
I tried to reset it and the entire network but it doesn't change anything.
Thanks
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Still having a problem with the P9 in Cabinet, You cannot connect the P9 in Cabinet to any power strip with filter or UPS, perhaps the electrical socket in the Cabinet is on a different electrical phase!
- Copy Link
- Report Inappropriate Content
Have you tested speeds near Deco P9 that report powerline links: what results you are getting now? Hopefully, better than wireless.
As for Cabinet P9, I think with this Deco model its power adapter plays the role in powerline link. To test if this is an adapter issue, borrow adapter from different Deco P9 and try it with Cabinet P9.
Other than that, it would be hard to tell what is wrong. There is no "special" synchronization, they all should work the same. Plug it to power outlet and if Deco P9 can establish powerline link, it will.
If you plug two Deco P9s one after another to same outlet and one can't establish powerline link but another can, the one that can't might have hardware issue.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1400
Replies: 15
Voters 0
No one has voted for it yet.