Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Stuck with pulsing green light during installation

< Deco

Stuck with pulsing green light during installation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Stuck with pulsing green light during installation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Coccodrillo_1

2021-06-18 13:07:09

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-06-18

Stuck with pulsing green light during installation

2021-06-18 13:07:09

Model: Deco M9 Plus

Hardware Version: V1

Firmware Version:

Every time I try to install the main unit it gets stuck in the "installing firmware" mode, with the green light pulsing for hours. How do I get past this problem? Internet connection is working.

1 Reply

TP-Link

2021-06-21 02:31:16

Posts: 6831

Helpful: 2902

Solutions: 535

Stories: 28

Registered: 2018-07-23

Re:Stuck with pulsing green light during installation

2021-06-21 02:31:16

@Coccodrillo_1

As per the LED status, it seems the Deco M9 runs into firmware recovery mode if you pressed the RESET button too long. Try to refer to the below article to get it alive:

https://www.tp-link.com/support/faq/2958/

Deco Monthly Recap- Check What's Currently Going on With Deco KidShield Test Recruitment, Share Your Ideas With us! Wi-Fi Schedule Ideas Wanted!

Coccodrillo_1

2021-06-18 13:07:09

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-06-18

Information

Helpful: 0

Replies: 1

Stuck with pulsing green light during installation

Stuck with pulsing green light during installation

Information

Voters 0

Tags