Massive issues following Firmware Upgrade
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Have had a 5 unit M9 Plus Mesh for ~5 months.
Worked seamlessly until latest Firmware update.
Following download and update, all slave units periodically dropped in and out of connectivity (red flashing light on deco unit).
Performed hard reset (manual) on main Deco, which then caused app to stop recognising prior setup network. Deleted and reinstalled app, same problem.
So to test, set up second network. Main Deco plus one Slave. This worked for 15 minutes, before same problem.
I now have two networks in my house: original one (which I am unable to reach as can't get past setup page through app) and secondary one which has the same problem as the original.
All after the firmware update.
Need advice on this! Have others had issues after Firmware update?
Cheers
I was reluctant to update my Deco M9s when I've got a notice of new firmware in Deco app, but I have not had issues after firmware update to 1.5.1. Haven't noticed difference in performance and stability. Satellite M9 stays connected.
I have 3-unit Deco mesh, one M5 and two M9s, maybe problems appear when Deco mesh has more units or runs under heavier load.
Also, my Satellite M9 unit has strong signal with Main M9, maybe when signal is weaker new firmware is not handling it well:
These are my Deco current firmware versions:
