Deco M5 satellite node always connecting to master node instead of a nearer satellite node
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a Deco M5 mesh network with one master node and 2 satellite nodes, say satellite_node_1 and satellite_node_2.
The node satellite_node_1 has good signal from the master node and no issues here.
And my node satellite_node_2 is nearer to the satellite_node_1. But still it is always getting connected to the master node which is more far, and thus having weaker signal.
How can I make my satellite_node_2 connect to satellite_node_1 instead of the master node?
Regards
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Please send the beta firmware for E4. I face the same issue.
Thanks
- Copy Link
- Report Inappropriate Content
I have a set up with 6 Deco M5 units for over a year now. All of them connect to the Master instead of the nearer satellites. The result is poor Internet in several parts of our house.
Could you send me the beta firmware that improves this issue? Thanks.
Could you also provide me with instructions how to install this, so I know what to do?
Thank you.
Best regards, Sebastiaan Vardy
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@TP-Link Same problem - I would like the beta firmware for my M4 and instructions. Why is the beta not readily available for download?
- Copy Link
- Report Inappropriate Content
@TP-Link i too would like to request this firmware. I'm struggling with the same issues having less than 10% connection speed because it's skipping the node between.
- Copy Link
- Report Inappropriate Content
Hi, please refer to this link to update to the latest firmware 1.6.0 on Deco M5:
Best regards.
--------------------------
Deco X50-PoE is ready for your advice. If you are interested, please help us complete the following survey.
- Copy Link
- Report Inappropriate Content
@David-TP Is this a manual download? I tried Update Deco on the app and the firmware I'm asked to download is version 1.5.7.
Also, is firmware 1.6 also available for Deco M9 Plus?
- Copy Link
- Report Inappropriate Content
@TP-Link I have this problem with my M4R's having just had to reset it all up again after getting a new Hub 5 from Virgin. 3 floors and the top floor will not connect to the middle one as it used to instead connecting to the main deco.
As an aside I also get 905mbps when the Hub 5 is in Router Mode and WiFi connecting direct. I put it in Modem mode to connect to the Deco M4R's and follow all the advised ways/orders to turn it on etc and then only getting 513mbps. Both times only my phone connected. Any advice on both would be appreciated. Thanks
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 8883
Replies: 39
Voters 1
