I have an EAP610-Outdoor AP and it was working perfectly for a couple of weeks, then one day the wireless stopped functioning. Everything else about the AP seems fine. The web interface works, it gets

Hi I recently upgraded my Omada Controller to v5.9.9. I have enabled "lock to ap" on some of my devices. However, one of the device that is locked to an EAP110 v4, has already connected to a different

i have EAP 670 V1 9 Device + Omada OC200 i use EAP 670 Fix only width160Mhz FW 1.0.3 in mode standalone & mode Adopt member in omeda in 2 mode every Wifi6 device & NB wifi6 client can connect EAP670 F

I just purchased and installed a new OC200 controller, ER605 router and an EAP670(US) AP. In my controller under the devices screen it says that new firmware is available. It shows that I have version

Hi, I have two EAP615s and one EAP610 configured with a single SSID on 5GHz using 80Mhz channels. I'm running Omada software 5.7.4 on a Linux server that is permantly powered/active. I've enabled fast

If both are mounted on a wall, do the EAP ceiling units provide better area coverage than the wall units? (disregarding the signal on the floor above and below) I am replacing wall mounted APs where n