nojakLV2Online
Following: 0Followers: 0
Forums/ WiFi
2020-06-30 14:20:35
Re:Terrible performance and 2.4 only
Denis, Since you're Apple, you can use the built-in wifi diagnostics on a Mac, or download NetSpot (free version) to see the channels and RSSI. Both do the same, but NetSpot can auto-update every 10...
0HELPFULS
Forums/ WiFi
2020-06-30 14:10:10
Re:2.4ghz network very slow in EAP245 and EAP225
@blj-74 Here are my 2.4GHz radio settings. I'm using the Omada Software Controller (on a Raspberry Pi) to control these, but that should not matter. Status: Enable Mode: 802..11b/g/n (mixed) <-...
0HELPFULS
Forums/ WiFi
2020-06-30 13:46:37
Re:2.4ghz network very slow in EAP245 and EAP225
I get normal speeds for 2.4GHz using both EAP225 and EAP245. Some interference from others, but not severe. North American versions, using latest firmware. I'm using 20MHz only and get ~60Mbps. PHY...
0HELPFULS
Forums/ Controllers
2020-06-24 03:28:35
Re:Omada SDN Hardware support
Maybe I’ve just been doing networking too long. Whe it comes to any switches, I don’t care for anything really beyond VLANs. QoS isn’t needed. If your L2 network is so complicated that you really...
1HELPFULS
Forums/ WiFi
2020-06-24 03:20:21
Re:Omada wired network question
@jonas thank you for the info.
0HELPFULS
Forums/ WiFi
2020-06-23 20:03:47
Re:Desktop/table mountable version of EAP225-Wall Access Point
Just put an EAP225 or EAP245 on a table then. It also works, though perhaps not most attractive.
0HELPFULS
12345...