R1D2 wrote I wouldn't investigate too much time into the WRT1200 setup as long as it isn't sure that it can handle VLANs and open source software can configure it. Usually, VLAN tags are just used...

R1D2 wrote Yes, the WNDR3700 will do it. I ported my OpenWRT-based software to the WNDR3800, which has the same architecture as the WNDR3700. OpenWRT firmware is identical for both models. The...

R1D2 wrote Does not sound good. Now I understand what you meant with "script": did you insert a switch config manually? Usually the default config includes anything supported by the chip. If there is...

[QUOTE=cayvman;202810]I didn't think it mattered. On another note, have installed OpenWrt Chaos Calmer 15.05.1 r49389, however, it doesn't have the Switch tab. I was able to insert a script in the...

R1D2 wrote Sorry, did forget this. Since OpenWRT's LuCI web UI uses a self-signed certificate with - meanwhile - weak signature algorithms, modern browsers refuse to accept it. Just ignore this. It's...

R1D2 wrote Not your fault. Linksys does anything to confuse people, me thinks. According to OpenWRT's wiki about the Linksys WRT1xxx series the WRT1200ac has a Marvell 88E6176 switch:...