Hello, I´ḿ currenlty using the X50 system in access point mode. But when seeing that static route setting is now available for use i tried it in router mode. In IPv4 : As there's no vlan on DECOs i...

Hello, today, i switched my master X50 deco into router mode in IPv4 and in IPv6 behind my ISP router. Bug : X50 gets my fd02::/64 network and associates with its own fd02::xxxx:xxxx:xxxx:xxxx...

@VladimirAlexiev Try "client mode" on dlink or archer, and keep deco as your network needs it to be (router or AP it is the same) : two APs cannot naturally communicate with each other unless being...

@Dinreko Did you restart or renew all the IPs on all your devices ? Switching to AP mode will remove the deco's private address range (and the DECO's router too). You'll be on your modem/router...

@VladimirAlexiev OKAY, through your last post i see a better picture of it. It seem to be at a lower level than i firstly expected. There's not established physical link. first DECO and Archer are...

@Dinreko This is not in the DECO but in your ISP modem/router that you'll find this setting (ISP documentation or data is required). If you don't know how to do the job safely : please stick to the...