@Tedd404 7 of 9 are wired. 2 were not.... Now all but one is wired. The unit that is not wired is an outlier, so no path back to create a loop. The resently meshed EAP245 that is now wired, but...

I'm having the same problem. Recreational complex. I have one EAP225 outdoor that is mesh tethered, but all other EAP's (225 Outdoor and 245) are wired. Gateway feeds PoE switch. EAP's are split...

@iampegram check the timing for log --> alert --> notification. See if there is a hidden nuisance timer that requires the issue to persist for 5 minutes (or whatever time) before it is logged......

@Hank21 Firmware are up to date per Omada distribution. OCC200 2.0 5.7.6 2.7.7 Build 20221206 Rel.58608. The disconnects DO get logged, just happens after a 5 minute delay. A disconnect that is...

@PHTP As you widen the BW, the radio output power is spread over that spectrum, resulting in less output power/MHz. Similarly, the receiver sensitivity drops. I'm thinking you would require a lot...

@paulrob I think it is simply to replace the port on the gateway that the OC200 occupies. I found myself short one Ethernet port in my initial deployment, and plugged an EAP110 into the OC200....