@ingeborgdot that seems odd. If you do a factory reset and the AP is connected to the same subnet as the controller it should work, unless you moved the controller to another VLAN other than 1??? As...

@ingeborgdot if you hold the reset for more than 5 seconds it will blink I think orange/green and that tells you its set to factory mode. The controller should then see it and place it in pending...

lflorack wrote Fleegle61 wrote @lflorack actually...I take back what I said.....I read the reddit article and if you put them in the correct order in the ACL list, it works. Put the ALLOW LAN TO IOT...

lflorack wrote Your point about allowing the ICMP protocol to get through made me think about this a bit more. Here's what I think is happening. Since the 'Allow' LAN to IoT ACL Rule is in place, the...

lflorack wrote Your point about allowing the ICMP protocol to get through made me think about this a bit more. Here's what I think is happening. Since the 'Allow' LAN to IoT ACL Rule is in place, the...

ingeborgdot wrote @Fleegle61 Yeah, all of this can get a little confusing when you're not a pro like some of you guys on here. I just don't know what the best option for my cameras are, as everyone...