I believe I may have to replace my existing OC200 (See that discussion here.) Anyway, my current OC200 is a V1. If I have to replace it, and I get the current V3 version, will I be able to use a...

@Fleegle61 See my update #2. In my case, it doesn't appear that it's the new firmware for either the OC200 or the 2210P that's causing the dropping/connecting/readopting device issues. But, if you...

Update 2: After downgrading both the OC200's firmware to v5.4.7 (in my update #1) and now the TL-SG2210P switch's firmware to 3.20.4 the looping drop/connect/readopt cycles continued overnight. From...

Update: After downgrading the OC200's firmware to v5.4.7 (as per my original post), the looping drop/connect/readopt cycles started again. I then remembered that I upgraded the TL-SG2210P switch's...

I installed the newly released Omada Hardware Controller v5.5.7 firmware on 2 September. It seemed to run Ok until this morning. When I say, 'OK', the OC200 has been losing connection/readopting a...

@dominguess I've seen this too with different clients. Just yesterday, my wife's iPhone was listed as wired to my main switch - even though it wasn't even in the house at the time. Here is my system....