Model :

Hardware Version :

Firmware Version :

ISP :

Hi,

I hope there are some true VPN cracks around here?
I am trying to connect my TPLink Archer MR200 (which unfortunately gets a private IP address from my spanish 4G provider) with my Fritz 6490 at home.
After hours of research and trial/error this is what I came up with... but have not been able to get the status ever changing from "down" to anything different...

TPLink side:

router internal IP: 192.168.179.1
router external IP: as said... a private one, thus dyndns isn't possible.

I created the following entry in Network > IPSec VPN:
ConnectionName: BerlinLaPalma
Remote Gateway: XXX.myfritz.net (the dyndns address of the fritz router)thi
Tunnel Access from local IP addresses: Subnet Address
Local Address: 192.168.179.0, Mask: 255.255.255.0
Remote Address: 192.168.178.0, Mask: 255.255.255.0
Key Exchange Method: Auto
Authentication Method: Pre-Shared Key
Pre-Shared Key: YYY (obviously the key I am using is a little longer (;-))
Perfect Forward Secrecy: Enable
Phase 1 Mode: Aggressive
Local Identifier Type: FQDN
Local Identifier: www.dummy.com (as said, I have a private IP, thus I was thinking using a dummy URL instead)
Remote Identifier Type: FQDN
Remote IDentifier: XXX.myfritz.net
The remaining entries are all with default values:
Encryption Algorithm: 3DES, Integrity Algorithm: MD5, Diffie-Hellmann Group: 1024 bit, Key Life Time: 3600,...


On the Fritz Side
Router IP is 192.168.178.1
I imported the following config file:

vpncfg {
connections {
enabled = yes;
conn_type = conntype_lan;
name = "BerlinLaPalma";
always_renew = no;
reject_not_encrypted = no;
dont_filter_netbios = no;
localip = 0.0.0.0;
local_virtualip = 0.0.0.0;
remoteip = 0.0.0.0;
remote_virtualip = 0.0.0.0;
remotehostname = "";
localid {
fqdn = "XXX.myfritz.net";
}
remoteid {
fqdn = "www.dummy.com";
}
mode = phase1_mode_aggressive;
phase1ss = "all/all/all";
keytype = connkeytype_pre_shared;
key = "YYY";
cert_do_server_auth = no;
use_nat_t = yes;
use_xauth = no;
use_cfgmode = no;
phase2localid {
ipnet {
ipaddr = 192.168.178.0;
mask = 255.255.255.0;
}
}
phase2remoteid {
ipnet {
ipaddr = 192.168.179.0;
mask = 255.255.255.0;
}
}
phase2ss = "esp-all-all/ah-none/comp-all/pfs";
accesslist = "permit ip any 192.168.179.0 255.255.255.0";
}
ike_forward_rules = "udp 0.0.0.0:500 0.0.0.0:500",
"udp 0.0.0.0:4500 0.0.0.0:4500";
}


// EOF


Anyone having any idea what I am doing wrong?