Problem with TP-Link WR841ND in bridge mode
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Problem with TP-Link WR841ND in bridge mode
Model :
Hardware Version :
Firmware Version :
ISP :
I have problem with TP-Link WR841ND, he is in bridge mode with first TP-Link router, the are connected wireless,so this is extended router, everything was ok until once. He broadcasting SSID but i can't connect. Also i can't access his control panel by entering address 192.168.1.2 , i connect him directly to pc from lan. First router is on address 192.168.1.1 and he is working fine. On first is DHCP enabled on this is disabled.
ipconfig /all
Also i try this because now i can't connect to router CP
This is second time that this is happend, first time i reset router and set parameters again , and he work until now.
This is how parameters are set
First router
Second router
I don't know why he stop working from time to time, i have warranty but i'm not sure am i made mistake or problem is in router ?
Hardware Version :
Firmware Version :
ISP :
I have problem with TP-Link WR841ND, he is in bridge mode with first TP-Link router, the are connected wireless,so this is extended router, everything was ok until once. He broadcasting SSID but i can't connect. Also i can't access his control panel by entering address 192.168.1.2 , i connect him directly to pc from lan. First router is on address 192.168.1.1 and he is working fine. On first is DHCP enabled on this is disabled.
ipconfig /all
Also i try this because now i can't connect to router CP
This is second time that this is happend, first time i reset router and set parameters again , and he work until now.
This is how parameters are set
First router
Second router
I don't know why he stop working from time to time, i have warranty but i'm not sure am i made mistake or problem is in router ?
Re:Problem with TP-Link WR841ND in bridge mode
I forget to say, this WR841ND is from my friend, and that 6pic with adsl2+ router is from my setup that are working fine for over a year ( i also have WR841ND as second router) and i set parameters for his setup at his home.
Now i success to access router CP , it was my mistake , IP address was 192.168.0.2 so when i change in windows default gateway to 192.168.0.2 i manage to access router, and from parameters i see , everything is set ok, i still do not know why he lose connection from first router and stop working
First router is at his home, because he working ok, i think he have TL-WR740N , and you can't screw up settings in first router, dhcp is on, ip adress range from 192.168.0.50 ,same wifi channel ...
Now i success to access router CP , it was my mistake , IP address was 192.168.0.2 so when i change in windows default gateway to 192.168.0.2 i manage to access router, and from parameters i see , everything is set ok, i still do not know why he lose connection from first router and stop working
First router is at his home, because he working ok, i think he have TL-WR740N , and you can't screw up settings in first router, dhcp is on, ip adress range from 192.168.0.50 ,same wifi channel ...