Archer C9 Ports Not Forwarding?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C9 Ports Not Forwarding?
Model : ArcherC9
Hardware Version : v1
Firmware Version : 3.17.0 Build 20150507 Rel. 34590n
ISP : PlusNet
Just replaced my old Billion BiPAC 7800N with an Archer C9. Everything looked good, and wireless speed was much improved. However, just noted that the port forwarding is not working.
Symptoms are exactly the same as the guy posting about his C7, which incidentally looks like he never resolved. I am in the UK on PlusNet with a static IP which is set up as PPPoE on WAN and connecting fine externally facing. I set up some forwards as normal, example below:
None of these I can access externally, and using a port checker can see they are not open. I even set up my local NAS/server in in the DMZ and that doesn't get traffic passed through either (well I cant see it using the open port checker).
So this has ended up as an expensive paper weight, and will most likely go back to the BiPAC, at least for the virtual server.
Any help much appreciated
Hardware Version : v1
Firmware Version : 3.17.0 Build 20150507 Rel. 34590n
ISP : PlusNet
Just replaced my old Billion BiPAC 7800N with an Archer C9. Everything looked good, and wireless speed was much improved. However, just noted that the port forwarding is not working.
Symptoms are exactly the same as the guy posting about his C7, which incidentally looks like he never resolved. I am in the UK on PlusNet with a static IP which is set up as PPPoE on WAN and connecting fine externally facing. I set up some forwards as normal, example below:
None of these I can access externally, and using a port checker can see they are not open. I even set up my local NAS/server in in the DMZ and that doesn't get traffic passed through either (well I cant see it using the open port checker).
So this has ended up as an expensive paper weight, and will most likely go back to the BiPAC, at least for the virtual server.
Any help much appreciated
