Home Network Community > All Threads > How To Configure TL-WR941ND As an Extended WiFi Device
< All Threads

How To Configure TL-WR941ND As an Extended WiFi Device

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How To Configure TL-WR941ND As an Extended WiFi Device

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How To Configure TL-WR941ND As an Extended WiFi Device
How To Configure TL-WR941ND As an Extended WiFi Device
2015-07-20 18:00:20
Region : Indonesia

Model : TL-WR941ND

Hardware Version : V3

Firmware Version : 3.13.9 Build 120201 Rel.54965n

ISP :


I'm trying to use TL-WR941ND as an extended wifi device along with ZTE MF90 4G Modem with following scheme:





ZTE MF90 IP Address: 192.168.1.1
WR941ND IP Address: 192.168.1.250
Laptop IP Address: 192.168.1.10

I have tried to configure them for bridging, but it still won't work
Here is few screenshot of the configuration and result status:

STATUS

















PING Result

Ping test to ZTE MF90




Ping Test to Laptop




Ping Test to Domain




Ping Test to Internet IP




Is there any wrong configuration that I had? or actually WR941ND can not perform this scheme?

Kindly help

Thank you
  0      
 
  0      
 
#1
Options
3 Reply
Re:How To Configure TL-WR941ND As an Extended WiFi Device
2015-07-21 14:16:54
No problem with your configuration. It should be a compatibility issue. Your WR941ND supports four address frame WDS while ZTE MF90 may support three address frame WDS... You may confirm with ZTE...
You have to buy a router which supports three address frame WDS or buy an AP and configure it in universal repeater mode.
  0  
  0  
#2
Options
Re:How To Configure TL-WR941ND As an Extended WiFi Device
2015-07-21 16:15:37
Sounds a bad luck for me that both of them can't be configured together,
but anyway thanks for your response Vivian,
  0  
  0  
#3
Options
Maybe routing / bridging issue on 941
2015-07-25 02:20:18
Ive got the wr841n with same issue.

In advanced routing - static routing list - add new - destination network 8.0.0.0, subnet 255.0.0.0, default 192.168.1.1.

This will let you test ping from 941 to 8.8.8.8 but still does not let laptop traffic through. This seems to confirm some issue on the 841/941 not forwarding traffic to the other end when wds status is RUN.

Question to TP-Link - In system routing table - should there not be a default route to gateway 192.168.1.1 in this case instead of 0.0.0.0 by default
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 4053

Replies: 3

Related Articles
How to configure TL-WR941ND as Repeater or Extend Wifi Signal
13976 0
How to configure TL-WR941ND as Repeater or Extend Wifi Signal
2335 0
TL-WR941Nd: configuration lost after power loss
499 0
TP link TL-WR941ND configure as repeater
2785 0
TL-WR941N vs TL-WR941ND firmwares
2605 0
TL-WR941ND Firmware error
890 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.