Configure a default route without using WAN
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Configure a default route without using WAN
Region : Brazil
Model : Archer C7
Hardware Version : Not Clear
Firmware Version : 3.13.34 Build 140402
ISP : NET
Guys,
Is there any possibility to input a "default route" to a another network device inside the LAN, I mean, without using WAN side?
My LAN subnet is 192.168.10.0 /24 and I need to configure a default route to an IP 192.168.10.2 for instance.
I tried to input:
Destination Network: 0.0.0.0
Subnet Mask: 0.0.0.0
Default Gateway: 192.168.10.2
Status: Enabled
The asnwer from the router was:
Error code: 4001
Bad destination IP address, please input another one.
I ´ve already handle many others router and there I´m able to do that.
What about this Archer 7, is it possible? As a router it have to be possible!!!
Tks
Hortolani
Model : Archer C7
Hardware Version : Not Clear
Firmware Version : 3.13.34 Build 140402
ISP : NET
Guys,
Is there any possibility to input a "default route" to a another network device inside the LAN, I mean, without using WAN side?
My LAN subnet is 192.168.10.0 /24 and I need to configure a default route to an IP 192.168.10.2 for instance.
I tried to input:
Destination Network: 0.0.0.0
Subnet Mask: 0.0.0.0
Default Gateway: 192.168.10.2
Status: Enabled
The asnwer from the router was:
Error code: 4001
Bad destination IP address, please input another one.
I ´ve already handle many others router and there I´m able to do that.
What about this Archer 7, is it possible? As a router it have to be possible!!!
Tks
Hortolani