WR1043 WDS bridge upgrade to WDR3600 fails
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WR1043 WDS bridge upgrade to WDR3600 fails
Region : Argentina
Model : TL-WDR4300
Hardware Version : V1
Firmware Version :
ISP :
I currently use a WR1043 connected via WDS to a Draytek gateway router to bridge two physical LAN networks at home and this is working without issue.
In order to up the bandwidth on the bridge I recently purchased a WDR3600 router to replace the WR1043 but although I follow exactly the same procedure and use exactly the same settings to establish the WDS connection on the new router, I can't get it to work.
Screenshot of the existing WiFi config attached.
DHCP disabled on TP-Link client, no MAC address filtering on Draytek host, both routers on same subnet with unique IP addresses.
Can anyone help me understand what might be going wrong here please?
Model : TL-WDR4300
Hardware Version : V1
Firmware Version :
ISP :
I currently use a WR1043 connected via WDS to a Draytek gateway router to bridge two physical LAN networks at home and this is working without issue.
In order to up the bandwidth on the bridge I recently purchased a WDR3600 router to replace the WR1043 but although I follow exactly the same procedure and use exactly the same settings to establish the WDS connection on the new router, I can't get it to work.
Screenshot of the existing WiFi config attached.
DHCP disabled on TP-Link client, no MAC address filtering on Draytek host, both routers on same subnet with unique IP addresses.
Can anyone help me understand what might be going wrong here please?
File:
