Home Network Community > All Threads > Wireless signal recognised - but cloned password not accepted
< All Threads

Wireless signal recognised - but cloned password not accepted

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wireless signal recognised - but cloned password not accepted

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wireless signal recognised - but cloned password not accepted
Wireless signal recognised - but cloned password not accepted
2014-05-03 07:30:53
Region : UnitedKingdom

Model : TL-WPA4220

Hardware Version : V1

Firmware Version :

ISP : Plusnet

Hi Everyone,

WPA 4220 Kit

I have finally got a wi-fi signal from my extender, which is recognised by my tablet. The lights indicate that I have successfully cloned the unit. I thought "cloning" meant that the Password would be the same as the password for
my existing wireless network, but I cannot connect to the TP Link using that password, getting the message "authentication problem".

It is probably obvious to you that my technical knowledge is poor in this area, so I'd be very grateful for any help you can offer.
  0      
 
  0      
 
#1
Options
4 Reply
Re:Wireless signal recognised - but cloned password not accepted
2014-05-04 14:00:08
If so, you can just quit using wi-fi clone.

Please use the PowerlineScan utility to log into the management webpage of your WPA4220, then you can configure your extender's wireless settings manually.
Here is the download link of this utility:
http://www.tp-link.com/en/support/download/?model=TL-WPA4220&version=V1#tbl_b

This link will help you configure your extender's wireless settings:
http://www.tp-link.com/en/article/?faqid=398
  0  
  0  
#2
Options
Thanks!!!!!
2014-05-05 06:23:56
Many thanks for your help - everything is now working perfectly.
  0  
  0  
#3
Options
WPA-4220 WPS wifi link successful, but devices won't login
2014-11-13 20:46:41
I have a similar problem. The WPS cloning worked fine. I've since checked the WPA4220's SSID and PSk password over Ethernet cable through the disc utility and they are the same as my home router.

Problem: Devices recognise the remote adapter, but can't login. After a time (8-10 mins est) the Powerline light goes out on the remote and the adapter just has a very slow blinking top light.

I live in an old, complicated house (made of stone, hence the need for wifi extension). Is this due to complicated wiring perhaps?
Is there a way round it?

I have other routers, could I set up a separate network instead?

All advice gratefully received...Many thanks,
FMS
  0  
  0  
#4
Options
Re:Wireless signal recognised - but cloned password not accepted
2014-11-17 17:34:13
If you restart the adapter on remoste site, how about status of all lights?
Is it possible for you to test if it works when it is in the same room as the one connected to router?
  0  
  0  
#5
Options

Information

Helpful: 0

Views: 1739

Replies: 4

Related Articles
Password to extender not recognised
18106 0
Password not recognised
338 0
Password not recognised
446 0
Am I cloned?
758 0
Password not recognised and can’t reset
498 0
Doesnt project Wifi once Cloned
610 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.