VR600 Address Reservation Problem
When trying to enter a mac address in the address reservation I get a gray box over this section of the page and can do nothing else without going to another page on the router setup.
There are lots of closed threads describing this problem in detail datig back to 2019 such as
https://community.tp-link.com/en/home/forum/topic/154927
https://community.tp-link.com/en/home/forum/topic/150863
https://community.tp-link.com/en/home/forum/topic/153807
But I can't find a solution on any of these despite replies from TPLink in those threads asking for information.
IS THERE A SOLUTION?
Thanks
Neil
HI @Marvin_S
Thanks for your reply - how the following fully answers your questions if not please come back to me.
The firmware is upto date - see screen shot below of the System - Firmware Uodate page.
I had narrowed down the ip address pool but now opened it back up so it is from xxx.xxx.xxx.1 to xxx.xxx.xxx.254
I have 18 mac addresses assigned specific IP address.
I did have 19 but deleted one and tried adding it back in but I got the same problem as the following screen shots
When you try to add an address reservation you get the screen as in next screen shot and if you are very quick you can enter the mac address
But the whole address reservation section goes grey after a few seconds as in next screen shot and you can't add any more information and the page freezes.
You have to click back on the left hand side menu to refresh the page to be able to do anything on the Lan Settings page.
This problem has been reported lots of times - surely a great company like TP-LInk muts have issued a fix?
many thanks
Neil