3G/4G backup failover not working

3G/4G backup failover not working

3G/4G backup failover not working
3G/4G backup failover not working
2024-11-21 13:03:16 - last edited 2 weeks ago
Model: Archer MR600  
Hardware Version: V3
Firmware Version: 1.2.0 0.9.1 v0001.0 Build 240716 Rel.54691n

The backup failover from ADSL to 3G/4g SIM not working (3G/4G SIM working as primary routing is fine). Followed instructions in setting up Network->Internet to 3G/4G as enabled with Dual Detection set to both IP address (8.8.8.8) and DNS (a.root-servers.net). If forced to failover, WAN interface shows Internet status as Connected, but there is no connection. The Basic page shows Intenret connection is 4G.

  0      
  0      
#1
Options
1 Accepted Solution
Re:3G/4G backup failover not working-Solution
2024-11-22 09:32:41 - last edited 2 weeks ago

  @ulysses888 

 

Hi, thanks for posting question here.

You may refer to tips in this thread to check more.

It is also suggested to contact local support for direct help.

 

 

 

 

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:3G/4G backup failover not working-Solution
2024-11-22 09:32:41 - last edited 2 weeks ago

  @ulysses888 

 

Hi, thanks for posting question here.

You may refer to tips in this thread to check more.

It is also suggested to contact local support for direct help.

 

 

 

 

Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 117

Replies: 1

Related Articles