Home Network Community > All Threads > "Operation Failed" System Parameters
< All Threads

"Operation Failed" System Parameters

"Operation Failed" System Parameters

"Operation Failed" System Parameters
"Operation Failed" System Parameters
2024-10-04 21:29:57 - last edited 2024-11-14 09:37:22
Model: Deco M4  
Hardware Version: V2
Firmware Version: 1.6.1 Build 20231227 Rel. 80438

Hello TP-Link Forum! I'm Eros, and I need help with an issue.
When I access the IP address of the Deco M4R WiFi (192.168.68.1) and try to enter the system parameters to change the WiFi coverage to High, I get the error message "Operation Failed." Even before trying to save the changes, just entering the system parameters triggers the error. I am attaching a screenshot.

Is there any way to fix this?

Thank you in advance for your responses!

File:
sis.PNGDownload
  1      
 
  1      
 
#1
Options
1 Accepted Solution
Re:"Operation Failed" System Parameters-Solution
2024-10-09 10:49:53 - last edited 2024-11-14 09:37:22

  @Eros438 

Hi, thank you very much for the feedback.

Usually, the web interface is not supposed to display the option to edit the WiFi coverage. It was reported by other users before, later the engineer has comfirmed that Deco doesn't support modifying the wireless coverage. This option is kind of the network caches and only showed up when the network connection is intermittent.

 

Thanks again and best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:"Operation Failed" System Parameters-Solution
2024-10-09 10:49:53 - last edited 2024-11-14 09:37:22

  @Eros438 

Hi, thank you very much for the feedback.

Usually, the web interface is not supposed to display the option to edit the WiFi coverage. It was reported by other users before, later the engineer has comfirmed that Deco doesn't support modifying the wireless coverage. This option is kind of the network caches and only showed up when the network connection is intermittent.

 

Thanks again and best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 1

Views: 183

Replies: 1

Related Articles
No System Parameters after upgrade to 1.6.1
365 0
Operation Failed message
981 0
VPN Client: Operation failed
1442 0
System Parameters on Access Point Mode
1840 1
Ax50 - System Parameters on AP Mode
1071 0
“Failed to log in”
449 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.